Win-Digipet - english forums > Win-Digipet Forum English

Train stops for no reason

<< < (2/2)

Per Olsen:
Did some more testing now...
Markus:  Do you mean a faulty RMK within the actual route?  I did some testing by making several RMKs within the active route, occupied, by setting a wagon on the track,  This had no effect on the trains, they kept moving (and would have crashed with the wagon if I did not remove it again :)  ).
I will test more later this evening...

Regards,
Per.

Stefan Lersch:
Hi Per,


very often the feedback contacts don't work properly. In that case an occupied contact won't be released it visa versa. That happens e.g. when the contact has minimal contact to the next one. In that case the route is not released properly and the faulty contact is still in the memory of WDP. If now a second train runs the same route the situation you described may occur.


That's the reason why Markus wrote you should check the log because there you can see it.

Per Olsen:
I am sorry, I never used the logbook.  Where do I activate it?

Rupert van Swol:
Per it,s alway,s at ON

Per Olsen:
Hello!

FOUND IT!  It was actually a mistake in a profile!  After a slow exit from a station, the speed is increased to standard running speed.  But instead, it was wrongly put to 0 rather than 70.

Sorry, my mistake.  But I finally found it!

Best regards,
Per Olsen.

Navigation

[0] Themen-Index

[*] Vorherige Sete