Autor Thema: Märklin m83 Decoder  (Gelesen 1876 mal)

Offline dconner

  • Senior-Mitglied
  • Beiträge: 100
  • Ort: Berlin Ort bei GoogleMaps suchen de
Märklin m83 Decoder
« am: 22. August 2019, 20:45:24 »
 Dear Forum, Many thanks to Marcus and his father for the English translation.
                     What am I doing wrong with my Märklin m83 decoder registration? I,m using it to operate the decoupling track, which works from CS2, but not from WinDigpet.
                     Best Regards-Dave CONNER.
  • Win-Digipet-Version:
    2021
  • Anlagenkonfiguration:
    märklin c gleis
  • Rechnerkonfiguration:
    DR5000 plus router

Offline Markus Herzog

  • Administrator
  • Senior-Mitglied
  • Beiträge: 16403
  • Ort: Rheinland Ort bei GoogleMaps suchen de
Re: Märklin m83 Decoder
« Antwort #1 am: 22. August 2019, 23:51:36 »
Hi Dave,

can you post a screenshot of the solenoid device configuration in the track diagram editor for the uncoupling track?

Regards
Markus
  • Win-Digipet-Version:
    WDP 2021.x Beta
  • Anlagenkonfiguration:
    3-Leiter Anlage, Rollendes Material Märklin/Roco/Brawa/Mehano, Fahren: DCC, m3 via Tams MC, Schalten/Melden: Selectrix, BiDiB, Motorola (nur wenige Sonderaufgaben)
  • Rechnerkonfiguration:
    Intel i7

Offline dconner

  • Senior-Mitglied
  • Beiträge: 100
  • Ort: Berlin Ort bei GoogleMaps suchen de
Re: Märklin m83 Decoder
« Antwort #2 am: 23. August 2019, 14:13:00 »
Dear Markus, Many thanks for the quick reply. Since last night I have discovered that Märklin have a newer m83 decoder:- 60832, which I have just ordered. I suspect that this new decoder will be more accesable than the older one for WinDigipet-mfx ?. If I may, I will keep you posted.

M.f.G. Dave Conner.
  • Win-Digipet-Version:
    2021
  • Anlagenkonfiguration:
    märklin c gleis
  • Rechnerkonfiguration:
    DR5000 plus router

Offline dconner

  • Senior-Mitglied
  • Beiträge: 100
  • Ort: Berlin Ort bei GoogleMaps suchen de
Re: Märklin m83 Decoder
« Antwort #3 am: 31. August 2019, 10:48:32 »
Dear Marcus, m83 decoder have been installed for the uncoupler track with the following anomolies:-
Märklin CS2 does not respond to a new activation time.
Windigipet has a possible 0 - 6 second activation time which has no effect either.
The Windigipet turnout test software only seems to recognise solonoid devices using MM as opposed to dcc and or Mfx ?
Later today I hope to be able to discuss these points with Bernd Senger at our WDP forum.
I wish you a great weekend and once again many thanks for your interest.

Dave Conner.
  • Win-Digipet-Version:
    2021
  • Anlagenkonfiguration:
    märklin c gleis
  • Rechnerkonfiguration:
    DR5000 plus router