Win-Digipet - english forums > Win-Digipet Forum English
Delay(s)
Per Olsen:
Hello.
I think I am missing something... This is probably easy, but I cannot see it. Maybe you can help?
I have a standard route (actually several, but lets focus on 1) for a train leaving a station. Works fine.
But this is the "problem": Right after leaving the station, there is a railway crossing. I have put in a delay in the automatic, so that after the route is activated, there is a delay of 8 seconds, so the crossing has time to close the gates before the train departs. But the "problem" is that the signal shows green at once when the route is activated, even before the gates are closed.
So I want the signal to wait for a certain delay after the route is activated (before the train starts moving) before it turns green to allow the train to leave.
So that the route is activated, but light is still red when the gates are closing, and THEN the light turns green, and then, after an additional delay, the train departs. As it would in real life :)
This is probably easy, but i cannot see it. Any help is appreciated.
Best regards,
Per.
Matthias Schäfer:
Hello Per,
Do you use a profile for this route?
Per Olsen:
Hi !
Yes, I may use a profile. Can I do it there ?
Regards,
Per
Per Olsen:
I think I found it in a profile. Will test :)
Matthias Schäfer:
Hi Per,
maybe you have to create a new route:
Route with the exit signal remaining on red.
Then in the profile you choose this route.
You start the route with the following profile:
Start
After some seconds you close the gates.
After some seconds more you turn the signal to green.
Some seconds more you start the train.
You turn the signal to red.
When te train passed the gates, you open them....
Did I get your idea?
This would be my idea, hope it works
Very best regards to Bergen (such a beautiful place)
Navigation
[0] Themen-Index
[#] Nächste Seite
Zur normalen Ansicht wechseln