Hello !
"Deep" in routes/zugfahrten/automatic-programming, I have discovered that I need something extra. Well, it MIGHT be there somewhere, but I haven't found it yet. Maybe you can help me..?
In "Zugfahrten-Automatic-Editor", there are some AND-conditions available. As f.ex. "Nur, wenn ruckmeldekontakte.." and "Nur, wenn Magnetartikel-Stellungen.." and "Nur, wenn Lok mit Farbe.." etc.
All these are "IF-AND-THEN" conditions. I mean, if you put in more than 1, the program really asks "If _this_ AND _that_ AND _next_ etc, is true, THAN the zugfahrt/route will be switched.
All this is VERY fine and VERY useful!
But now I am in a position where a need a lot of IF-OR conditions in addition to all the current IF-ANDs. Is this possible somewhere, using Zugfahrt-Automatic ?
I need to test "IF track A is free/busy OR track B is free/busy OR track C is free/busy etc, THEN" switch the route/Zugfahrt.
Also "IF Magnetartikel A is red/green OR Magnetartikel B is red/green etc, THEN" switch the route/Zugfart.
Etc.
Best regards,
Per, Bergen, Norway.
Hi Per,
this is quite easy: As you've already mentioned the entries in ONE line are always AND-conditions and the Route or Tour will just be performed if ALL of the entered conditions are TRUE.
To enable OR-conditions simply enter the same line TWICE (or more if necessary) with DIFFERENT conditions.
Regards
Rüdiger
Hello.
Yes, I know this. I have done this for a long time. But the number of lines can be very big, like this. I have very many lines that are inserted 2-4, even 8 times, with different conditions. I would like to reduce the number of lines, and with OR-conditions, I could reduce them a lot. And also much easier to control and read my own programming.
I can only hope for this to be implemented later. It can do no harm, only good....
Per.
Hi Per,
let's put it this way: We never say never...
Considering that the German version is around 9 months in advance and up to now nobody asked about a different solution there is obviously no urgent demand right now.
In the way I described you are able to use AND and OR conditions. If you state that it may increase your amount of lines up to 8 times then I assume there would be a different solution to configure it more efficient.
Nevertheless even a max. of 800 lines for one single Tour-automatic seems to be convenient, 'cause nobody obviously touched the limit (yet).
But let's see what the future brings and of course - as usual - we collect also all user needs and wishes for eventually future releases.
Regards
Rüdiger