Hello,
I am a freshman in the forum, so I take the opporunity of this first mail to greet everyone here.
I experience the following problems with the routes editor:
1) although I place a train on the start contact , when I test the route, I get the message that the staring contact is not occupied.
2)when I use the start/destination function I get the message that the route is locked. that happens with every route I have used more than once, so I believe that for some reason the routes are not released even though the train reaches the destination contact.
Thank you,
Dimitris from Greece
Hello Mr.Skaltsas,
it's a little bit difficult to give an advice in this case without knowing you data.
I believe there is going something wrong with your feedback contacts or your switching / release conditions inside your routes.
Please send me a backup (zipped) of your project. I'll try to find a beta tester who can control your data, because I have no time to do it.
best regards
P.Peterlin