Hallo all.
When I have put a routes in a time table and after that run a test of the inputs, the arriving time is not calculated. Is that correct or do I something rung. I'm using the latest version of WD and my interface is IB.
Best regards
Alex
Hello Mr. Hansen,
Zitathe arriving time is not calculated.
strange ... the arriving time will be calculated immediatelly when the destination contact of a route was reached !
Please control this contact within the routes editor and be sure that the release conditions of a route are correctly anyway.
Sorry it's my mistake what I meen was when I'm using a tour in the time table then the arrival time is not calculated. Of course is the arrival time calculated when I'm using a route :-[
Hello Mr Hansen,
that's OK ! This function is only for a single route !
A tour can't be calculated exactly, because you can get always different times f.e. if any block (route) inside a tour was free or not.
best regards
P.Peterlin
OK, but then I think it's a little useless to have the possibilty to use tours in a time table, because you don't know when you can give a start time at the end destination.
But anyway thank you for your quick answer.
Best regards
Alex Hansen