Hallo please, using "routes wizard" the program not accept the number track diagram. I make that error?
::)
Hi Sean,
WDP won't recognize these symbols as normal track symbols. you have to define pairs of jump points to put a route over them. please see the picture i attached, youu will find the symbol within the track editor.
Greetz from Berlin
Bernd
+++
Tank you Bernd
Sorry Bernt jump points I not bidirectional?
hi Sean,
jump points are bidirectional. let me create an example for you a little bit later.
regards, bernd
+++
Ok Bernd ;D
Hi Sean,
you'll find a little example attached to this mail. The following steps to create jump points are necessary to be done:
- open the track editor
- define the symbols to jump over
- open the editor for jump points
- create a new jump point with a pair of track symbols (pull the symbols with left-click&hold into the editor (see example)
- define one direction for each track symbol where to jump (see example)
- after work is done, dont forget to save your jump points
After this process the track wizard in the main program will be able to jump over special parts of your track layout (e.g. characters).
Have fun
Bernd
Dear Sean,
to me it looks like you added the track numbers as simple text (using the "abc" icon). Alternatively you can use the feedback numbers (sorry, I don't know the correct english translation for that). You don't need jump points then! Simply replace your numbers by the feedback numbers, that's it. These numbers also highlighten when the section is allocated.
Maybe someone with an english WDP edition can make a screen shot of the numbers I meen. If not I could give you at least a screen shot of the german version. I'm sure you will find those numbers anyway!
Hallo Stefan
Tank you for your response,but I dont found this numbers, can I found here?
Hi Sean,
please check under "Train number tracking display". Delete the old numbers from your tracks (using the rubber) and add the new numbers instead. I use them, too.
Ok tank you :D