I have WDP 2009-3b + I IBCOM.
FB are working fine.
When a route is running, and a car rolled by accident to a block in the route. the block become RED, but the train dose not stoped.
What can I do to cause the train to stop.
Yaakov
Hello Yaakov,
Was the route set before the car rolled into the block? If so, the preconditions were fulfilled and the route was
already activated, the train will not stop in an activated route until the stop contact is reached. If the car rolled into the block prior to the route being set then the route should not have been activated and the train should wait until the route is clear. If the car rolled onto the stop contact in the block then the train would stop prematurely.
Hope this helps,
Elliott
Thnks
That exactly what happened. But I expect that WDP will have the option of stoping the train if a block in the route is occupied, even if rhe car rolled at the muddle of the route execution.
yaakov
Hello Yaakov,
no, it doesn't. It's testing at the moment when it reaches a start contact. If the start conditions are ok at that moment it wouldn't test again while it's on the way.