Hi,
one more Uhlenbrock question... Don't think it is a WDP problem, but maybe someone here has some clues..
Whenever I power on the system, then Uhlenbrock Feedback Module 63330 does not report any trains/indications, but there are trains on the track. If I remove the train and set it back, then the Uhlenbrock Feedback Module 63330 reports occupation as expected....
Any clues to why it does not report after power off/on?
Peter
Hello
LNCV 20 must be 4.
Yaakov
Thanks ! It works! Peter
Hmmm.... after a power down, then the UB has forgotten this setting... Anything I need to do to save the setting? Peter
I am using the IB UTIL to set the 63330.
Yaakov
Hi,
so do I.... but it seems it somehow forget the configuration... At least everytime I start up WDP can not see the occupiancy... Hmmm...
Peter
After programung the 63330 with IB util, you must disconnect the 63330 from the electricity, otherwise the 63330 is in programing mode. it have some red light on, and the WDP dose not see it.
Hmm... does not seem to help..
If I power up, and then disconnect/connect the 63330, then it works... or if I program anything (e.g. just address), then it starts working...
Hmmm....
Peter