Hello to all
I am new to the forum and just starting in digital, although I have a long history with analog railroading. My question concerns what we call "switching" in the USA, maybe Rangierbewegung? Using ZFA, I set up a simple maneuver summarized as position A>position B, B>A, A>C. The problem is that WDP executes A>B, B>A, A>B, B>A....until I shut it off. From the various diagnostics, it seems ZFA totally ignores the command line A>C and just returns to A>B. The simulation does exactly the same as the actual railroad. I have tried many variations and always get the same result.
What have I missed? Any help will be greatly appreciated.
Regards
Hello Mr. Hahnwald,
now you have found the right place to ask all folks ( and not using a PN to me)
OK, you need a condition with a virtual solenoid device. ( see manual)
For example : switch the route from A > B only if the vitual solenoid device is green otherwise switch the route from A > C.
Simple set this solenoid device inside the Tour automatic red or green. From A > B set it to red ! And so on
Understand ?
regards
Hello Herr Peterlin
That seems clear; I will try it. Thank you.
Regards
Hello Herr Peterlin
Yes, that works. Many thanks.
Regards