Dear WDP/Märklin enthusiast/spe*censored*ts. My Märklin Transfer Table does not work under WDP ver.12.1. With my Märklin CS2, under keyboard, I do get a response, the transfer bridge moves from 901 to 909 and back again.
One question:- Under HELP, section 15.3, starting with the paragraph "Now you have to assign also for all 9 .....you have to select <Loc assignment>. My small selection menu does nor have this <Loc assignment>. ?????
When the transfer table bridge is occupied, the corresponding feedback signal is registered in my CS2 layout plan, but not in my WDP layout !!!! etc..
What am I doing WRONG ????
Gruß / Regards
Dear WDP Entusiasts etc., I installed a USB mouse on my laptop which has enabled me to see "Loc assigngment" etc.. With my laptop touchpad I did not see it !!
Gruß / Regards