Hi,
I have a route working well , but I get the attached message at the end of it.
The only thing which seems to not work properly is the stop @signal with the intelligent train number display with no effect when I try to change the stop distance.
Can anyone give me explanations???
Regards
Hi,
do you run this route with a profile? It seems that you have contact 1 in your profile but contact 1 is never reached. If you do not have a profile then check your route for contact 1.
Hi Stefan, thanks for your help.
I am not using profiles with this route, I check I have no route for contact 1 and this route does not contain contact 1.
Also as I wrote, the train always stops in the same position (asking for a stop @signal) even if I change the signal position value.
Could the length of the train be a link compare to the Intelligent train number display?
Regards.
Hello,
last question first, yes, that's right. If a train is too long to stop in the middle then it would continue to the last contact. But you requested a stop at the signal. If there's no contact 1 in your route then check if you have that contact in your iTND.
If you still don't find contact 1 then please provide a backup without the loco pictures and without the symbols.
Vtefan,
I will check.
I forgot to mention than it does not happen in simulation mode.
Regards.