Hello Guys
We are getting a error message that says this.
Run - Time error13
Type Mismatch
once you press ok it shuts down Windigipet. Then when you restart and go back to time table you keep getting the same problem.
James
Hi James,
close the WDP main program and start the WDP data maintenance. Press on "repair and compress". Restart the WDP main program. Did it help?
Hello stefan
This did not work at all. we are still getting the problem. please see attached project.
We have been trying to clearn up the track plan errors and when we do this and then use the new fixed route this gives us the ERROR 13 can you please help.
Many Thanks
James
Hello,
Maybe restore the latest working Backup ?
Grtz
eric
Hello Eric
We did that and as soon as you make any changes and then go in to the time table it happens again.
James
Hi James,
and a backup from a oldery date then a few days before this problem apeared ?
It's possible that this problem is also present in the latest backup.
Otherwhise you could have a problem in the program its self.
Normally a good backup should clear the program.
grtz
eric
The back up does clear the problem but then when I want to make changes to the track plan and write new routes the problem comes back again.
James
Hello James,
I think Markus has to have a look at it because you might have an invalid character or value in a field.
Hello James,
what about your first line. It is missing !!
I checked your timetable without any problems also within the simulation.
It could be that your timetable is corrupt. See attached your timetable.
Please check your timetable always with the simbol " note of exclamation "
regards
Peter
Hello Peter
This project is one of my customers. The first line is missing because when the error came up this was removed.
I the Time table is corrupt can it me fixed?
James