I have a route built which works well when tested but when running during the programme the points do not change, this causes short circuit when loco tries to go over point.
Help
Chris
Hello Chris,
a point works exactly like a "normal" turnout. Does the point switch when you click it in the track diagram without running a train?
Hi
Yes points change as they should both on the diagram and also when testing the route. also works Ok when the train is returning in the opposite direction.
Thanks
Chris
Hello Chris,
ok, then please give more details when exactly they don't work.
Hi Stefan
I have made the route as the first movement in my timetable, I tested and all worked well, when I ran the timetable the points did not change.
James advised me to make a second timetable and add the route which I have done and all is working well.
I have several routes set to operate at the same time, do you think I am asking for too much to happen at the same time?
Thanks
Chris
Hi
My mistake,
thanks to everyone for the help. I was not seeing the obvious.
Thanks
Chris
Hi Chris,
that's good but what was it?
We fixed it Wohoo!
Hello,
I'm also interested in what the obvious was.
Aloha,
Elliott
Hi
Due to a few problems I set up a 2nd timetable but some how missed that I did not have the route for the train in the new timetable. I missed the obvious. I am now going thru my timetable to spread out the number of routes that change at the same time hopefully this will then run better, I think I was asking for too much to happen at the same time.
Many thanks for all the help
Chris