Hello
On my wishlist for the next update of windigipet is.
1. Support for swedish signalaspects.
2. Support for Litfinskis Light-Signal Decoder LS-DEC-SJ
http://www.ldt-infocenter.com/dokuwiki/doku.php?id=en:ls-dec-sj
Reg/Lasse
Zitat von: Lassenor in 03. Februar 2015, 17:03:10
Hello
On my wishlist for the next update of windigipet is.
1. Support for swedish signalaspects.
2. Support for Litfinskis Light-Signal Decoder LS-DEC-SJ
http://www.ldt-infocenter.com/dokuwiki/doku.php?id=en:ls-dec-sj
Reg/Lasse
Hello
I am not sure if is available within the small edition but i think that you can use the multiaspect signal option to control your own signal aspect via any signal decoder.
Wait for Stefan to confirm my suggestion....
Bye
Hi
Pierangelo
I think it can be possible to edit the signal aspect.
But my four aspect signals uses the adresses each.
I haven't have time yet.
Reg/Lasse
Hello,
yes, this is included in the small version!
Hello,
Zitat2. Support for Litfinskis Light-Signal Decoder LS-DEC-SJ
Is there a reason why this is asked ?
Is this not a question of te right System ?
Grtz
eric
Hi
Because I use LDT LS-DEC-SJ lightsignaldecoder which is not supported yet.
But LDT LS-DEC-DR is supported by Windigipet.
Regards
Lasse
You can use multi-aspect signals option at WDP and edit it according to specific decoder.
On my layout I use PKP signals with Digital-Bahn decoders. For this purpose I edited also symbol graphics. Every light signal contains two parts: the upper one shows allowed max. speed at the next signal; the lower part refers to actual limits. It looks like:
Zitat von: Kuba in 06. Februar 2015, 01:53:22
You can use multi-aspect signals option at WDP and edit it according to specific decoder.
On my layout I use PKP signals with Digital-Bahn decoders. For this purpose I edited also symbol graphics. Every light signal contains two parts: the upper one shows allowed max. speed at the next signal; the lower part refers to actual limits. It looks like:
Hi Kuba
Thanks for the useful information and the images.
I didn't know the graphic was editable too, then it will be no problems with my light signals. :D
Regards
Lasse
Hello Lasse,
the graphic editor is not included in the small version as far as I know.
Hello Lasse,
Forgive me if i asked a stupid question, i'm only a beginner. But i read :
ZitatBecause I use LDT LS-DEC-SJ lightsignaldecoder which is not supported yet.
As far i know there is no system setting where you can add a signal decoder.
You have a signal decoder with a default setting concerning signals. Such as DB, NL or any country.
This decoder you connect at your digital system, and your digital system sends the controll signals to switch the signaldecoder.
Of course wdp has some standard settings for signals and it is possible that your signal setting is not available. But just like Kuba showed there is a fine solution.
But your Signaldecoder has to be the one who is able to switch ....
Grtz
eric
Hello Stefan,
the graphic editor is not included at any English version. I copied it from German Demo, and it works.
Another way to edit graphic is to open the file from C:\WDIGIPET_INT\Symbole\... with the Paint application or another editing software.