Hello.
Look at 3.jpg and 4.jpg. This Zugfahrt Works fine, the actions in Options works.
Look at 1.jpg and 2.jpg. This Zugfahrt is very similar, except that it starts with a reversal of direction of travel. In this case the actions in Options do NOT work.
Is there an obvious reason for this? I have struggled with this for 2 days now, maybe you can help me? :) :)
Best regards,
Per.
Modified: Sorry, I could not upload 4.JPG (to many Mb total). But it is almost identical to 2.JPG, shows only the options.
hello Per,
ZitatModified: Sorry, I could not upload 4.JPG (to many Mb total). But it is almost identical to 2.JPG, shows only the options.
if you process your pictures to resize them with f.e 60% you can upload more pictures and the upload is faster. For the other readers the pictures will be at a size that is easier to read what your problem is. now i must scroll a lot to see what you meant.
about your question.... it's not completely clear to me what the actions must do and don't ... is this because of the wrong direction ?
I had a simular problem and discoverd that if you use a "wenden" (turn), that this "wenden" comes sometimes other then planned... as soon this command is in a Line it is executed before starting ...
Also remind that if you have a profile with a "wenden" this is also excecuted, so a double "wenden" is possible..
maybe this is info is a possible solution for your problem...
Hello Per,
After looking at this briefly, the only difference I can see is that you have a wait of 5 seconds in 3.jpg. Could this be the problem?
Aloha,
Elliott
Dear Per,
I see that the options are at K=0 which means at begin of the execution of the row in the ZFA.
I do not know the program code but it might be that this is disturbed by the <wenden> instruction which also comes at the begin of the execution.
Maybe you could work around by using the first rmk of your FS/route.
Just an idea
Good luck
Luc Diels
Hi all.
I have tried to remove this Message, but I am not allowed to do so. Don't know why...
It is not a problem any more. I have solved it by re-Programming. Thanks anyway!
Best regards,
Per.