HELLO
Sorry for my English who is not good but i try to explain my problem.
I have the new L 60883 Märklin and i have installed WDP 2015.
I even install the patch for Märklin L 60883 that MARKUS had developped at the beginning of the month of may.
It works very well for the BUS 0 and the BUS 1 ,but for the BUS 2 and the BUS 3 ,it doesn't work.
i think the problem become of that we have only 1984 possible contacts and for the BUS 2 we need the contact 2000 to 2496 and for the BUS 3 we need contact 3000 to 3496.
Somenone can confirm me this problem or is it possible to make it differently?
Thank you for you answer
best regards
JEAN PIERRE
Hello JEAN PIERRE,
no there is no problem, you just have to make a different configuration.
Win-Digipet can use up to 248 8-port-feedback modules, now lets count:
-contacts of L88 module no. in L88 1-2 -> 2 modules
-S88 contact at Bus 1 module no. in L88 126-187 -> 62 modules
-S88 contact at Bus 2 module no. in L88 251-312 -> 62 modules
-S88 contact at Bus 3 module no. in L88 376-437 -> 62 modules
In sum these are 188 feedback modules.
So if you really have 62 feedback modules per bus, you could config it in WDP like this:
-from module 1 to 2 WDP Start modul 1
-from module 126 to 187 WDP Start modul 3
-from module 251 to 312 WDP Start modul 65
-from module 376 to 437 WDP Start modul 127
By this you can map the usable module numbers of the L88 to any module numbers within WDP.
Regards
Markus
Hello MARKUS,
Thank you very much for your fast answer.It's great.
I try your purpose and all is ok!
Thank you very much again 😀
I hope that it has been succesfull for someone else.
Best regards