Hello.
I am re-designing my old layout for WDP 2015. So there are many un-finished parts, please ignore them... But there is one error that I cannot figure out. Look at my enclosed Project. After leaving the track editor I always get the error-message that "Train number display (084,020) does need exactly 2 Connectors!".
Am I doing something wrong here? What?
Best regards,
Per.
Hello Per,
this error-message will tell you, that you have to provide at the right and left side of the 3-field-train number display a single track symbol. When there is e.g. a Signal Symbol directly aside of the train number display, this will cause this error-message. Same Regulation is valid if the train number display is in vertical direction.
Hope this will help you.
Hello Ralf!
Thank you for Your answer.
Well, I do of course know this, so I do have one single track section on each end of the 3-field Train number section. So that should be OK. I do have a track symbol 1 directly to the right of this, belonging to another track. Does WDP think this is a Field that belongs to the same track as the 3-feld train number? Could be... The error-message disappeared when I replaced that 1-number With a single track....
Regards,
Per.
Hello Per,
yes, that's exactly the reason. In your case it's not a mistake so you can ignore the message.
Hello Stefan!
OK, that Clears it :) So it is safe to ignore it. I'll do just that.
Thank you !
Best regards,
Per.