Seite drucken - No contact with the I.b

Titel: No contact with the I.b
Beitrag von: Uzi Zadikov in 19. Dezember 2003, 17:10:10

Hi to all

when I start run the Win-digipet & it is checking the points & signals I get a notice that is no conection between the I.B & the computer.
I have to go through the prog setting & chose again the com port & save, then I get the conection again.
This can also happen in the middle of the program.

Way is this?

Thanks
Uzi

Titel: Re: No contact with the I.b
Beitrag von: Peterlin in 20. Dezember 2003, 11:06:06

Hi Uzi,

this could be a data error inside your track diagram regarding a solenoid device address.

Please go to the system settings and click off the solenoid device switchings during program start. Then it runs ?
Test this feature with a little new project !

A little bit strange is that the IB looses the connection in the middle of the program

! A fault of the IB ?

best regards
P.Peterlin

Titel: Re: No contact with the I.b
Beitrag von: Uzi Zadikov in 10. Januar 2004, 15:08:30

Hallo Dr. peterlin

I perform refreshing (carry out basic setting) to the the defolt position of the point & signal.
Now evrything work excellent.

Thanks
Uzi

windigipet.de

Win-Digipet - international => Win-Digipet Forum English => Thema gestartet von: Uzi Zadikov in 19. Dezember 2003, 17:10:10