Hello.
Today I had to make a full reset of my TAMS controller. After that, I started WDP, and installed the newest update, 2018.2c.
When I started WDP again, all contact is lost to all turnout decoders. All feedbacks are working, and I can control the locos. But all turnout-decoders are dead.
Any quick idea as to what I have done wrong?
Regards,
Per.
Hello Per,
can you switch the turnouts using the Tams (without WDP)?
Hello!
I never tried that before :)
I tried now. According to manual, I should put in the address of the turnout, NOT press OK, and then F1/F2 to switch it. Did not work. I tried F3/F4 (as the display shows), did not work either.
Did I forget something that I must input again in the Tams controller...?
Sorry to bother you with this, my problem...
Regards,
Per
Hello Per
Are you using turnouts via DCC or Motorola format?
Maybe you have to set the turnout format in the Tams again
Regards
Markus
Hello!
I just found it myself! I use Motorola for the turnout decoders, and the Tams was set for DCC. I changed it, and now all is OK.
Markus: I already fixed it, but thanks anyway! :) :)
Have a nice day!
Regards,
Per.