Hello everybody,
I bit annoying problem with WDP 2018 2c.
After closing the program, the next day, I open it, and I see all locos lost their original location on the software, while keeping the prior locations on the tracks. This is not the first time that happens and I have quite few locos on the layout to reprogram on the original location, what should I do to void this problem ? is this a bug in the software ? Thank you so much for any help ! :) Filiberto
hello everybody, any feedback ? Thank you so much
Hello Filiberto,
you cannot expect an immediat answer. Sometimes it takes a while until someone reads your question. No, there's no bug in the software. I assume that you don't end the software properly. You have to wait until all of the trains stopped. Then you can exit the main program and thereafter the start center. If you switch off your PC earlier this will result in the problem you have.
Thank you Stefan for the answer.
I understand your point, and will make sure to follow carefully your suggestion and come back with the outcome. Have a nice w end, Filiberto