Hello Forum members,
I have three BidiB booster on my model railway.
Two boosters are for powering the Rails. ( two separate circuits )
The third booster is only for powering and controlling the turnouts, signals and other switchable controls. I notice that when starting WDP the third booster is not activated.
The turnouts ( rails only ) are assigned to a booster but the third Booster ( power supply DCC ) for the turnout is not.
Is this because the third booster is not assigned?
kind regards,
Rupert
Hello Eric,
Is the third booster maybe not registered in the Booster management and is maybe for this booster not set the option in the booster management to to start it on track signal power on?
Regards
Markus
Hello Markus,
and indeed the Booster was assigned, but the check mark on booster parameters " start booster after program start " was missing.
Also this again solved.
greetings
Rupert