Hello
After installing the new Tams Mc2 today :) , there are many mutations such as linking this central to the loco decoders.
After a manual check it was time to give a driving command from WDP . Everything is correct and seems to work, however the locomotive does not physically respond to a driving command or function command from WDP 2018.d
There is voltage on the track, as the locomotive does respond well to the function commands and driving commands of a hand controller which is connected to Xnet.
This means that the internal settings of the central unit are ok and set to DCC with 28 speed levels.
The turnout commands from WDP are executed properly as are the signals,
I do not know where I should change a forgotten setting .
Any ideas?
Kind regards
Rupert van Swol
Hello Eric,
please attach a data backup of your project.
I´m operating this system with a really large layout via BiDiB protocol since weeks with DCC, MFX, m3 and so an without any problems.
I will try your project if the loco commands of your project react on my setup.
Regards
Markus
Good morning Markus
The track plan data you requested has been sent to your email address. It was refused by the server ( error uploading )
I'm also going to continue looking, that's what you learn the most from.
But thanks for helping me.
Kind regards .
Rupert
To All,
The problem no longer exist. :) :) :)
kind regards
Rupert