Hi
I dont see any feedback from contacts.I have a cs3(not +). I use wdp 2018 and are a new to this program.All feedbaks works on cs3.When I took the picture the cs3 ,the contacts where yellow on cs3.I can operate the trains and turnouts from wdp.Atm , On cs3,I only have 1 Link 88 and and a S88 connected on Bus 1.The m83/84 works fine
The feedback works from link88.I changed the Nr to 2.But what number should the next S88 have?
Hi,
if the next modul is on the same bus (0) so behind the first module, you only have to increase the final modul in this bus to "modul 4"
I only have 1 Link 88 and a S88 connected on Bus 1 on the link 88.I dont get any feedback on s88 modul
I,ve tryed to change "strang" .In my systemsetting/feedbackmodul,I have a field where I set "2",Thats the id from my cs3 link88 setting.(It was a tip).With this setting L88 2Bus 0 ,all 16 contacts worked.The s88 modul is connected to bus 1 on the link s88.I,m not able to get any feedback from it on wdp.It work on cs3.
Hi
If you have just connected one module with 16 ports to bus 1 you to select bus 1 from module 1 to module 2 WDP start module 3 (as you have selected start module 1 for the module at bus 0), but bus internally the counting for from and to always starts at 1 again
Regards
Markus
Thanks alot,it works ;D
(//)The third modul does not work.The fourt modul works fine but that one is on bus 2
It's ok now :D