When activate a tour (start/destination) to pick up wagons, the route is activated, but the Loc itself do not startup
Both the start block and end block are occupied in this case and setup in <Route-editor> Tab:Switch condition=F/O for actual end blocks
Anyone have a tip to this case?
Dear Kiv,
Hello Kiv,
I myself use carriages without axle/wheel detection.
And it is often the case that the direction of travel of the remaining train (collection of carriages) no longer corresponds to the direction of travel of the connecting locomotive.
Try it out: change the direction of travel of the train to be connected and the locomotive will depart.
It is strange that you do not mention a warning.
This situation was already reported in Windigipet 21, and you can solve it with a macro consisting of one command: reverse the direction of travel of the train.
All the best
Rupert
hello
Rubert
Macro to change direction do not cure this issue
Yes, strange that no error message is given, the start/destination menu only show where to stop (image below)
The actual tour is controlled by profile-1
rgs
Kiv