Roco Single slips

[James Hudson]

Hello Guys
Hope you can help me i am struggling to get a single slip working right. It a Roco point with two point motors but as it a single slip and not a double slip WDP still tyres to switch it fours ways so only 50% of the time it is right. Please can some one shed some light on this for me.

james

[Stefan Lersch]

Hello James,

that's correct like that. Don't worry about the "impossible" positions. Because you will create routes over that slip and you will create possible routes only. In that case WDP will never set the slip to an impossible position.

[James Hudson]

Hello Stefan

But this does not seem to be the case. I always seem to get it working in certain routes but then if i cross the single slip form another direction it seems to go wrong. I am a little lost. it only one point out of about 40. This is on a customers layout i have built. If i send you the WDP project can you have a look?

James

[James Hudson]

It ok have it working now! had the address for the point the wrong way round.

James

[Stefan Lersch]

Hello James,

that's good and would have been my first question (because you can't see that in the project without the real layout).