How to delete/replace a track symbol?

[Per Olsen]

Hello.

Look at the Attached Picture.  In the middle, there is a turnout that should not be there.  I did have a turnout there earlier, but the layout changed, and I deleted the turnout and replaced it With a standard straight track symbol.  Looking in the editor, the track is correct.  But in the standard window, it is still a turnout.  I tried several times to delete it, restart, replace it etc.  But still the same.

What have I done wrong, and how do I fix this?  All Works OK, but it looks a bit strange...

Best regards,
Per.

[Ralf Krapp]

Hello Per,
please try this: Open the Editor, click on the rubber and delete the turnout with the rubber. Then click on storage symbol and close the editor. Then again open the editor and place the straight track symbol in the empty field. Once more click on the storage symbol and close the editor.
I hope this will help you to solve your problem.

[Jürgen Gräbner]

Hallo Ralf,

I hope this will help you to solve your problem.

ich glaube nicht....

Übersetz doch bitte mal folgendes:

Meiner Meinung bildet die "Phantomweiche" zusammen mit der Weiche rechts daneben eine DKW. Bitte lösche mal beide Symbole, speichere und zeichne danach nur die Weiche wieder ein.

[Stefan Lersch]

Hi Per,

Jürgen asked to translate his answer. He is concerned that your phantom turnout and the turnout to the right form a double slip switch in WDP. Please delete both turnouts and add the the correct turnout thereafter.

I'ld like to point out that you need to alter all routes that go over this section. Do not delete them but use the camera symbol to change them.

[Per Olsen]

Hi !

Ralf:  This is exactly what I had done, did not work.
Jurgen:  You were right.  I deleted also the turnout to the right, like you suggested.  Now it is OK.
Stefan:  All routes were warned, so I fixed them (as normal) as you also described.

Thank you all !

Best regards,
Per.