Deactivate digital system by default

[Andrzej]

I use Fichtelbahn Speedometer to calibrate vehicles from OpenCar System. It works very well. The problem is with simultaneous operation of the RF-Basis and the Speedometer. Radio signals sent by both are interfering with each other. In fact, at the specific time only one of these is needed, i.e. RF-Basis at the time of regular operation, Speedometer at the time of calibration. To avoid interference over the radio communication, only one can be turned on.
So, my question is about new option to deactivate digital system on the list by default. Especially regarding systems used only for calibration.

Another issue, not of high importance, vehicles which can drive only forward, truly do not need backward calibration.

[Markus Herzog]

Hello Andrzej,

Both wishes are already realized.

In the Startcenter before you start the Main programm you see on the right side a list window also showing your digital systems. Right click on of the systems you will find a option to deactivate it "temporialy". This means it will not be initialized when starting the program.
But you can initialize it later by clicking on the digital system number in the main program.

Regarding measuring just forward:
When selecting a measurement by way/distance: you will find a button to select that you measuere on a round course (necessary for just one direction) and beside a button will appear to select the direction.
When selecting a roller stand you can select in the lower part of the window just to measure single points and within the subwindow to select the single points you can already select with directions to measure.

Regards
Markus

Regards
Markus

[Andrzej]

Hello Marcus,
that was a quick solution. And it really works. I just needed to make a note, i.e. 'nota bene' to remember it in the future.
Thank you!