No contact with decoders..!

[Per Olsen]

Hello.

Today I had to make a full reset of my TAMS controller.  After that, I started WDP, and installed the newest update, 2018.2c.

When I started WDP again, all contact is lost to all turnout decoders.  All feedbacks are working, and I can control the locos.  But all turnout-decoders are dead.

Any quick idea as to what I have done wrong?

Regards,
Per.

[Stefan Lersch]

Hello Per,

can you switch the turnouts using the Tams (without WDP)?

[Per Olsen]

Hello!

I never tried that before
I tried now.  According to manual, I should put in the address of the turnout, NOT press OK, and then F1/F2 to switch it.  Did not work.  I tried F3/F4 (as the display shows), did not work either.

Did I forget something that I must input again in the Tams controller...?

Sorry to bother you with this, my problem...

Regards,
Per

[Markus Herzog]

 Hello Per

Are you using turnouts via DCC or Motorola format?

Maybe you have to set the turnout format in the Tams again

Regards
Markus

[Per Olsen]

Hello!

I just found it myself!  I use Motorola for the turnout decoders, and the Tams was set for DCC.  I changed it, and now all is OK.

Markus:  I already fixed it, but thanks anyway! 

Have a nice day!

Regards,
Per.