No contact with the I.b

[Uzi Zadikov]

Hi to all

when I start run the Win-digipet & it is checking the points & signals I get a notice that is no conection between the I.B & the computer.
I have to go through the prog setting & chose again the com port & save, then I get the  conection again.
This can also happen in the middle of the program.

Way is this?

Thanks
Uzi
 

[Peterlin]

Hi Uzi,

this could be a data error inside your track diagram regarding a solenoid device address.

Please go to the system settings and click off the solenoid device switchings during program start. Then it runs ?
Test this feature with a little new project !

A little bit strange is that the IB looses the connection in the middle of the program  ! A fault of the IB ?

best regards
P.Peterlin
 

[Uzi Zadikov]

Hallo Dr. peterlin

I perform refreshing (carry out basic setting) to the the defolt position of the point & signal.
Now evrything work excellent.
Thanks
Uzi