Strange_Division_Route

[kiv@vftronic.no]

In a <division route> I divide the train by using telex in a profile, when uncoupling is executed the train starts running forward as expected, but after a sec it suddenly stops, see image below.
By checking the speed in the train-menu I find it set to 40 km/t and that is correct, but trains do not move at all. By clicking the speed bar down to 35 km/t the train starts again and journey completed. It seems to me that a kind of stop signal is sent to the train by the software when telex is used.

Because by removing the telex uncoupling in the profile then train run the journey correct, except the wagons are not disconnected.

I m out of ideas need some help

[Markus Herzog]

Hi,

Please check when this happens if the speed command is still visible on the CS3.

I am sure, that you will see the speed command greater 0 still on the CS3. And if this is the case, it is not in the program´s influence

Regards
Markus

[kiv@vftronic.no]

Hi

I already found the reason of error. By adding a new line in the profile include delay timer of 3 sec, next line after the profile line "telex off" everything start working perfect.

Regards
Kjell Ivar