Those tracks are connectec to S88, and the problem is that not always detects the seccions occupancy.

Hello,

are these always the same tracks? Have you tried to change to decoders?

Zitat von: Stefan Lersch in 19. März 2011, 22:08:33
Hello,

are these always the same tracks? Have you tried to change to decoders?

I've checked all connections. The problem is that the signal to S88 is send, sometimes, when the train passes, but when it stop's these not detect, it shoulds stay red, but not. What can be the problem. Anyone?

Hello,

could you please fill in your signature. I need information about what you use and what you drive. AC or DC?

If this happens always at the same track it might be a decoder problem. If it happens always to the same train but at different tracks than than it might be that your train needs additional resistance.

Zitat von: Stefan Lersch in 20. März 2011, 21:39:27
Hello,

could you please fill in your signature. I need information about what you use and what you drive. AC or DC?

If this happens always at the same track it might be a decoder problem. If it happens always to the same train but at different tracks than than it might be that your train needs additional resistance.

Hi,
Is AC system, with a CS2 and S88 feedback.
I've checks that it works with only one secion connected, it detects a train in that secion,  if i try to connect another it stops giving occupation information and doesn't work.

Hi,

as far as I know (I don't have a CS2) it is necessary that you have a track in your WDP layout with the highest possible feedback contact number. If you don't have a track with this number in your WDP layout than simply add one.

Zitat von: Stefan Lersch in 20. März 2011, 22:04:09
Hi,

as far as I know (I don't have a CS2) it is necessary that you have a track in your WDP layout with the highest possible feedback contact number. If you don't have a track with this number in your WDP layout than simply add one.

I do have several contact numbers, but if a train is on a section it detects, the problem is when i connect other secions, with other numbers, it stops working.
I don't know what is wrong.... help needed.

Hi,

have you done what I wrote - inserting a track with the highest possible feedback number?

Zitat von: Stefan Lersch in 20. März 2011, 22:12:37
Hi,

have you done what I wrote - inserting a track with the highest possible feedback number?

Hi there, Yes I did, I fufill all 16, S88 connections but if is there a single train it detects his presence, but if another trais get into other seccion it stops giving any information.
Can the S88 be demage?

Hi,

yes, that might be. Does this happen all over your layout or only at some tracks and always the same tracks? In the first case I would check the connection to the CS2. In the 2nd case I would exchange the affected decoder with another one that works fine.

Hello,

Do you have the ground wire connected or disconnected.  If connected, try disconecting it or vice versa.

Hope this helps,

Elliott