Hi,
In X.3 English , the single cross give error. The route contains two invalid symbol !
Unfortunnately I could'nt add the image inside of this message! ( how know how to add image )
I have this message with two cross and 10 routes.

Hello André,

Since you made this route, did you change something in your WDP railplan?, i.e. did you change some symbols?

Kind regards,
Gerard

Thanks,
I have rewrite all routes with invalid symbol, I will test soon
André

Hi Gerard, I have rewrite all route with error (exclamatuin mark) , all is ok now.
Except  at one place with 3 routes I still have the error "Add-on 1: Solenoid-symbol not in line with the track layaut" there is no exclamatuin mark, I have recreate those routes, withour success.
How is it possible to send the image with the trouble?
Best regards.
André

Hi André,

Make a printscreen of the image, then open it in paint and put this image in a map (save as).
Then in answer a topic below, you see extra options. Over there open your map where this image is in and put this image (file) together with your answer.

Thanks,
Here are the last trouble in the track image.
I never use the oblique signal.
Thanks inforward
Andre

Hello André,

Zitat von: André Grandmaison in 16. Februar 2008, 10:59:28
Except  at one place with 3 routes I still have the error "Add-on 1: Solenoid-symbol not in line with the track layaut"

I assume you changed this symbol before, or not? And did you record this symbol in these 3 routes in the routes-editor as well?

Kind regards,
Gerard

Yes Gerard,
I have corrected those symbol several time ( two place with the same error) , and I never use the oblique symbol
best regards
André

trouble solved by moving the signal.
Thanks and regards
André