Attention message

[kiv@vftronic.no]

Hello
Train friends

Occasionally, a message appears on the screen, but it disappears after a very short time, making it impossible to read.

I managed to capture the message by recording a video, but I do not understand what is wrong with Journey ID 49. Configuration for ID49 in the attached images.

Any advice on what could be causing this message would be greatly appreciated.

Regards
Kjell Ivar

[Bernd Senger]

Hi Kjell,
This message informs you aboute a missing upcoming contact (mostly Brake contact) during the process of a route. It must be deleted by the program very quickly due to performance reasons. You will find these messages in the logbook of WinDigipet.

[kiv@vftronic.no]

Hi Bernd

Thanks for the help! I found the message in the logbook now. I was so focused on looking for it on the screen that I completely forgot to check the log.

It turned out that the error was caused by a section of the route where there was no signal due to a cable fault.

Thanks for your tip!

But why does this message box disappear before you have a chance to read it? It is a bit confusing, especially since there is an <OK> button in the message box that is normally used to close such messages.

Great software, that even find serious errors

Regards
Kjell Ivar