How to stop a train by block signal

[kiv@vftronic.no]

Trying to stop a train using a event/profile at a defined block, I can't get this to work with my setup.
The stop point (block 67) is marked with a red frame on the sketch.

any tips how to do that, or what page to read in UM?

I also try to follow the tour event by menu <Tour Event Inspector>, but how to avoid that info is cleared at the moment actual tour is completed, found a button <Refresh Automatically>, but still all info disappear.

[Bernd Senger]

Hi Kjell,
please refer to the order of contacts and the description below the list of contacts. And of course, there's no two-way configuration needed for this vehicle display (except your locos ar able to fly  )

[kiv@vftronic.no]

Hi

Sorry, No flying trains in my system for the moment
But, no it seems to work, the train halt/stop just 1-2 cm in front of the stop buck

My new setup:
-Move Vehicle display to last block 67, see parking
-Then it was possible to use 67 as stop signal, see tour
Only one minor case, breaking speed start at 15 cm, not 60 cm as my setup in vehicle display

rgs
kjell ivar