Loco will not move at all.

James Hudson · 19. Januar 2014, 18:10:56

We have a loco on the layout that will not drive through Windigipet at all. Even if you manually drive with the virtual throttle. But if I use the Intellibox it drive perfect.

Any ideas? I have checked address in loco date base and every thing I can think of and still no luck.

Thanks for your help

James

Stefan Lersch · 19. Januar 2014, 18:19:47

Hello James,

it seems you have the wrong protocol. Check that you have entered MM, or Dcc or whatever the loco has in WDP.

James Hudson · 19. Januar 2014, 19:35:31

Hi Stefan

That's for all your help.
I have attached a picture of the loco we have the problem with. It look right to me but may be I am missing something.

James

Stefan Lersch · 19. Januar 2014, 20:48:43

Hi James,

I see that this loco is not calibrated but this is not the problem. Nevertheless please go into the calibration and have a look at the speeds to the right. Look for the horizontal red bar. It should be at the top. Is it at the bottom? If yes move it up.

If no please make a backup of your project without the loco pictures and symbols and attach it here. Please tell me if it runs sometimes or never with WDP.

James Hudson · 20. Januar 2014, 20:52:41

Once I have backed up the project. How do I put it on here?

James

Stefan Lersch · 20. Januar 2014, 21:04:38

Hello James,

make sure not to include the loco pictures nor the symbols. Then your backup should be less then 2 MB. On the bottom of the forum click on "Reply", not on "Quick Reply"! On the next page below the text you will see Attachments. Click there and select your backup.

Chris Hall · 20. Januar 2014, 21:21:17

The file is still over 5MB have attached a screen shot of how we are do the backup.

Stefan Lersch · 20. Januar 2014, 21:23:28

Hi,

the picture is too small!

Chris Hall · 20. Januar 2014, 21:27:50

Hi
larger picture

Stefan Lersch · 20. Januar 2014, 21:42:56

Looks good to me. And still > 5 MB?

Chris Hall · 20. Januar 2014, 21:45:29

Hi
5.2MB

thanks
Chris

Stefan Lersch · 20. Januar 2014, 21:47:38

I just created a use-only-once email address. Please send the zip to wdp@trash-mail.com. Please leave me a note here when you did so.

Chris Hall · 20. Januar 2014, 21:53:05

Hi Stefan

Email sent from Bluebirdenviro@googlemail.com

Thanks
Chris

Chris Hall · 20. Januar 2014, 21:56:34

Hi Stefan

File rejected by e mail address as to big

thanks
Chris

Chris Hall · 20. Januar 2014, 22:05:22

Hi Stefan
James has given me another way to send file but I will need an e mail address
Thanks
Chris