Zimo MX10 with Roco 10808 and Roco 10809 possible in WDP2025PE?

[Rupert van Swol]

Today, I connected the Roco10808 feedback to the Zimo MX10.  On the CAN connection
First, I installed the new SW versions.
Something is definitely happening, and I found it in the log description of the Zimo MX10 log.
I also don't know how to find the Roco module number.
But I'm still a beginner on this "Zimo interface."
Nothing I've tried has worked.

The fact that the Roco 10808 is compatible with the Zimo MX10 is evident from the fact that this combination works perfectly in a recent update from a Dutch software developer Xander Berkhout .
Is this combination already possible in WDP2025PE?

kind regards

Rupert

[Markus Herzog]

Hi Rupert,

I normally read the adresse of the Roco 10808 or a Zimo StEin Modul in the list of StEin modules within the MX32 throttle of Zimo which is connected to my MX10.
The address has initially assigend to the 10808 when the module has been connected to a Roco Z21 while using the Z21 maintenance tool. According to the short manual of the detector it is also possible with button on the board and a turnout command, but I have never tried this.
You can start using WDP with the module only after you know the address from programming or from the the MX32/MX33 throttle.

When you enter the address in WDP it might be necessary to add +1 to the address because the numbering scheme has been changed some times ago. My 10808 with address 1 reports for WDP at the moment on address 2 (and it was working with MX10 in my tests 5 minutes ago). We will eliminate this offset in an upcoming update.

Regards
Markus

[Rupert van Swol]

Hello Markus, thank you for this tip.
I am not yet familiar with the ZIMO system, let alone the STein and all its possibilities.
But I will get there, now that I know I can find the feedback address on the MX33.