Stop error

[kiv@vftronic.no]

In the menu journey editor> stop is set to "end of platform", but some time the Train stop just by entering the block (4 in setup). It is hard to understand, because by running several laps (5) and it stop perfect for every lap. Then suddenly it stop and beginning of platform. Seems to happen when a new train is started, but not 100% shure that is the reason.
Is there a log anywhere to read why the train is forced stop?
Or a tip what to check for this issue.
See image for actual setup.

[Bernd Senger]

Hi Kjell,
please make sure, that the stop-contact doesn't "blink" sometimes. You can dot that within the Logbook (option: record feedback events) or in the feedback configuration window (option: display feedback log.

regards from the city of berlin
Bernd
+++

[kiv@vftronic.no]

hello
I found a feedback log in the menu , seems for me that all feedback's is set on/of several times. I don't find a way to save the log to a file, menu therefore image enclosed.
If I add a delay timer in <feedback menu> the train will run future into the block, by increasing to 5,5 sec it stop when all of the train enter the block (end of platform). But I don't believe at all that that this solution it a work around.
My feedback's are controlled by HSI-88_USB, Marklin train system.
Finlay it seems for me that this problem occur only at block (4) trains using blocks 1,2,3,5 run ok.

[kiv@vftronic.no]

I found something that may cause this error, at block 1, one of block 4 was inserted, strange that it was not discovered by me earlier. I will correct and do a new test and let you know the result.

[kiv@vftronic.no]

My finding do not solve this issue, it is something else. I believe now that there is something unstable with the system, it might work, but then it doesn't work again. For the moment I'm confused.
What always cure the problem is the feed-back delay-timer.